Axminster AWFS18 Provozní pokyny stáhnout pdf (Strana 14)

Setup/Adjustments

Operating Instructions

Setting the Anti-kick back guide:

Place your work on top of the work table and lower the anti-kick back guide by loosening the grub screw on the

cast iron block, see ﬁgs 16 & 17, so it is just above work piece. Re-tighten the grub screw and lower the blade

guard (D).

Fig 16

Loosen the grub screw which clamps the anti-kick

back guide.

Fig 17

Position the anti-kick back guide, so it is just above

the work piece.

Anti-kick back guide

clamping screw

3mm Hex key

Work piece

If you are new to scroll saws, there will be a learning period, a period to learn the saw itself, and a period

to learn how the wood and saw work together. Expect some blade breakages, scroll saw blades are fairly

fragile, compared to blades found on a bandsaw or circular saw.

UNDER NO CIRCUMSTANCES SHOULD CHILDREN BE ALLOWED IN WORK AREAS

PLUG IN AND SWITCH ON THE MAINS

SEE THE COVER OF THE MANUAL FOR WEARING THE CORRECT SAFETY

PROTECTION WHEN USING THIS MACHINE.

Make a last check that everything is secure, that the blade is tight and all none essential items have been cleared

away from the work area. Connect a dust extraction unit or vacuum cleaner to the dust extraction outlet on the

fretsaw.

Turning “ON” the Scroll Saw:

1. Open the NVR switch shroud and press the “Green Button”, which put power to the

master on/off switch, to the front of the variable speed control unit. (See ﬁg 18).

NOTE: MAKE SURE the Variable Speed knob is turned down to “LOW”. (See ﬁg 19).

2. Switch on the scroll saw by pressing the master switch to the “ON” position. (See ﬁg 19).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Žádné komentáře

Axminster AWFS18 Provozní pokyny Strana 14