Axminster AWFS18 Provozní pokyny stáhnout pdf (Strana 19)

Changing the Blade

Changing Standard Blades:

9. Insert the saw blade clamps into the saw blade positioning guides (J), to the right side of the table.

10. Loosen the hex screws (K) on the blade clamps, using a 3mm allen key. REMOVE the blade.

11. Insert a NEW blade into the blade clamp slots (see the blade symbol embossed on the positioning guide).

Tighten the two hex bolts to clamp the blade in position.

12. REPLACE the blade assembly as previously described on page 18 in reverse. INSTALL THE BLADES AS

RECOMMENDED BY THE MANUFACTURER.

3mm Allen key

Blade clamp slot

Changing Standard Blades (Pin Ends)

CLEAN THE UPPER AND LOWER BLADE HOLDER BEFORE INSERTING

A NEW BLADE & CHECK THE BLADE FOR DAMAGE.

1. Repeat 1 to 8 on the previous pages, to remove the

standard blade.

2. INSERT the pin ended blade through the centre of

the table.

INSTALL THE BLADES AS RECOMMENDED BY THE

MANUFACTURER.

3. Slide the blade into the lower cradle (H) so that the

pins on the end of the blade engage in the recess in the

housing. (See page 20)

4. Press down the rocker arm and slot the blade

through the upper housing and lower the pin ends into

the cradle (G).

5. Pull the tensioning lever (E) back.

6. Turn the tensioning knob (D) (ONE FULL TURN

CLOCKWISE)

7. Replace the table insert (C).

8. Lower the upper blade guard (A) and push up the

lower guard (B) (beneath the table).

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Žádné komentáře

Axminster AWFS18 Provozní pokyny Strana 19