Axminster AWFS18 Provozní pokyny stáhnout pdf (Strana 21)

PROBLEM

PROBABLE CAUSES

SUGGESTED REMEDY

Breaking Blades

1. Incorrect tension.

2. Overworked (worn out) blade.

3. Wrong blade being used.

4. Twisting blade in wood.

1 Adjust blade tension.

2. Reduce feed rate or replace blade.

3. Use narrow blades for thin wood,

wider blades for thicker wood.

4. Avoid side pressure on blade.

Motor Will Not Run

1. Defective cord, plug or outlet

2. Defective motor.

1. Unplug saw, replace defective parts.

2. Repairs MUST be made by a

qualiﬁed technician. Call Axminster

Tool Centre. (Technical Sales

Phone: 08700 600388).

Excessive Vibration

(Some vibration is inevitable when the

saw and motor are running)

1. Improper mounting of saw.

2. Unsuitable mounting surface.

3. Loose table.

4. Motor mount is loose.

1. See proper mounting instructions.

2. Replace plywood workbench

surface with solid lumber surface.

3. Tighten table clamping knob.

4. Tighten motor mount screws.

Blade Runout

(Blade not in line with motion

of Rocker Arms).

1. Blade clamps not aligned.

1. Loosen the blade clamping knob (F).

Adjust position of blade clamps. Use a

90˚ square to verify alignment.

Re-tighten clamping knob (F) &

continue operation.

Maintenance

Troubleshooting

3. The motor is permanently lubricated. Do not try to oil the motor bearings or service any internal parts of the

motor. If the power cord is worn, frayed, cut or damaged, contact Axminster Power Tool Centre. Do not try to

patch it up with electrical tape, this could lead to more trouble.

Fig 20

To gain access to the drive bearings, remove the

side panel by undoing the Philips screw,

counter-clockwise.

Fig 21

Once you have removed side panel

lubricate the lower arm/drive bearing

with 3-IN-ONE oil.

OIL

Lower arm

4. Frequently blow out any dust that may accumulate inside the motor. An occasional

light coat of oil on the table to prevent surface rust is recommended.

5. Occasionally wipe the machine over with a damp cloth.

6. If the fretsaw is not going to be used for a period of time, smear a light coat of oil over the work table and place

a dust sheet over the fretsaw. (Part no: 600410).

1 2 ... 16 17 18 19 20 21 22 23 24

Komentáře k této Příručce

Žádné komentáře

Axminster AWFS18 Provozní pokyny Strana 21

Komentáře k této Příručce

Související produkty a manuály pro Kotoučové pily Axminster AWFS18