Axminster AWFS18 Provozní pokyny stáhnout pdf (Strana 8)

Insert the two hex bolts you removed earlier to

secure the NVR assembly

Initial Assembly

Mounting the NVR Switch Assembly:

Fig 5

You may need to remove the cable

covers on the NVR assembly

to gain access to the hex bolts

Fig 6

Cable cover

5mm

Hex key

Hex bolt

Fitting the Air Delivery Tube:

1) Locate the air tube assembly (C), undo and remove the 1/4” BSP brass ﬁtting (See ﬁg 7). Insert the threaded end

of the air tube (C) through the pre-drilled hole to the base of the NVR assembly bracket (B). (See ﬁg 8).

2) While holding the air tube (C) in position screw the 1/4” BSP brass ﬁtting back on.

(See ﬁg 9).

NOTE: The tting may be tight as it is new, you may require a 17mm spanner to tighten it fully

Fig 7

Undo and remove the 1/4” BSP brass

ﬁtting from the air tube assembly

Fig 8

Insert the air tube’s threaded end through the

pre-drilled hole in the NVR bracket

1/4” BSP brass ﬁtting

Fig 9

Fig 10

Push on the plastic air hose onto the end of the

brass ﬁtting until it is fully home

Screw the 1/4” BSP ﬁtting back on the air tube

assembly using a 17mm spanner

Plastic air hose

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Žádné komentáře

Axminster AWFS18 Provozní pokyny Strana 8