Axminster AWFS18 Provozní pokyny stáhnout pdf (Strana 7)

Initial Assembly

Fig 1

Fig 2

Undo the two grub screws

Fig 3

Slide on the blade guard and lightly

tighten the butterﬂy bolt

Slide the angle support rod through the two

pre-drilled holes & tighten the grub screws

Angle support rod

Grub screws

Cast iron blocks

3mm Hex key

Fig 4

REMOVE the two hex bolts in readiness for

mounting the NVR assembly

Hex bolts

Mounting the NVR Switch Assembly:

The NVR switch is mounted to a steel angle bracket

(B),to the base of the bracket there are three pre-drilled

holes, two of the holes are for ﬁxing the assembly to

the fretsaw arm while the third is for securing the air

delivery tube (C). You will require a 5mm Hex key and

a 17mm spanner. Please follow the instruction below.

1) Loosen and remove the two hex bolts from the cast

iron arm. (See ﬁg 4).

NOTE: Support the arm to stop it from dropping

onto the table.

2) Line up the two holes in the NVR switch bracket with

the pre-drilled holes in the cast iron arm and secure

using the two hex bolts you removed earlier. (See ﬁgs 5

& 6 on the next page) (DO NOT OVER TIGHTEN)

NOTE: You may need to remove the cable covers on

the NVR switch to enable a 5mm allen key to gain

access to secure the hex bolts.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Žádné komentáře

Axminster AWFS18 Provozní pokyny Strana 7