Axminster AWFS18 Provozní pokyny stáhnout pdf (Strana 17)

Operating Instructions

Adjusting the Blade Stroke:

On the motor drive wheel there are two pre-drilled holes for adjusting the blade stroke from 10mm to

20mm, please follow the instuctions below for changing the stroke.

Motor wheel drive assemblyUndo the side panel to gain access to the drive wheel

Undo the lower arm drive bearing using a 8mm socketPlace a steel rod into the recess to the side of the drive

wheel (B), to hold the wheel in position

Re-secure the lower armThe left hole is for 10mm strokes and the

right for 20mm strokes

1. To gain access to the drive wheel, remove the side

panel (A) by undoing the Phillips screw,

counter-clockwise, place assembly safely aside.

2. Place a steel rod into the recess to the side of the

drive wheel (B), to hold the wheel in position.

3. Undo the lower arm drive bearing using a 8mm

socket (C) and reposition to the adjacent hole to

change the stroke, re-secure.

Note: The left hole is for 10mm strokes and the right

for 20mm strokes.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Žádné komentáře

Axminster AWFS18 Provozní pokyny Strana 17